StewMac fiddle kit

Kevin Sjostrand
Posts: 4109
Joined: Sat Feb 09, 2008 8:06 pm
Location: Visalia, CA

Re: StewMac fiddle kit

Post by Kevin Sjostrand »

Looking really good!

On the necks I've been just wiping on 2 or 3 coats of shellac and steel wooling it smooth. Seals the wood, is nice and smooth and gives some protection helping to keep "dirt" from getting into the wood.
MaineGeezer
Posts: 1842
Joined: Wed Aug 13, 2014 12:14 pm

Re: StewMac fiddle kit

Post by MaineGeezer »

Life has intervened a bit,. which has slowed progress. I've gotten some things done though. Gluing on the neck with HHG went very well. All the alignments and angles came out as expected, which was quite satisfying (and a huge relief).
i added the tailpiece (probably not called that on a violin, but you know what I mean) and chin rest. The chin rest clamps onto the violin body with two turnbuckle-style clamps. A loop on the tailpiece slips over the end pin and presses on a small block of ebony called the tailgut saddle that is inset into the top edge of the violin.
With the tailpiece in place and the neck attached, I could think about stringing it up!
Well, not quite. The bridge had to be addressed first.
You do not have the required permissions to view the files attached to this post.
Don't believe everything you know.
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
Kevin Sjostrand
Posts: 4109
Joined: Sat Feb 09, 2008 8:06 pm
Location: Visalia, CA

Re: StewMac fiddle kit

Post by Kevin Sjostrand »

You did a great job. I bet it sounds and plays like a violin too!
Post Reply