Changing neck type

Bright Ideas That Work? Tell Us!
Post Reply
nehsgolfer
Posts: 87
Joined: Tue Mar 11, 2008 9:09 am

Changing neck type

Post by nehsgolfer »

Is there any reason why I couldn't turn a dovetail joint into a bolt on joint by putting bolts in through the neck block and not gluing the joint ??
tippie53
Posts: 7011
Joined: Fri Mar 03, 2006 7:09 pm
Location: Hegins, Pa
Contact:

Re: Changing neck type

Post by tippie53 »

you can but it will work against the dovetail
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
MaineGeezer
Posts: 1711
Joined: Wed Aug 13, 2014 12:14 pm

Re: Changing neck type

Post by MaineGeezer »

You might do better if you changed the dovetail to a straight mortise and tenon, but I'm not at all sure how one would go about doing that. I think you would have to fill in the cutout in the neck block in the body,fill in the sides of the dovetail with tapered wedge-shaped pieces, then cut the mortise and tendon.

I'm doing a mortise and tenon bolt-on neck on the Regal mandolin overhaul, but I wasn't starting with an existing dovetail joint and I'm carving a complete new neck.
You do not have the required permissions to view the files attached to this post.
Don't believe everything you know.
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
Post Reply