Well then... how 'bout spraying early in the morning?
Also, I can't state for a fact that humidity is a deal breaker. It is just my experience that the spray mist is marginally finer when I'm not breathing water. Can temperature is much more of a factor.
Behlen Vinyl Sealer Problem
-
MuddyFox
- Posts: 146
- Joined: Thu Apr 28, 2011 4:00 am
-
nehsgolfer
- Posts: 89
- Joined: Tue Mar 11, 2008 9:09 am
Re: Behlen Vinyl Sealer Problem
OK, I caught a day today that was 90 degrees and humidity 48. I got the last coat of sealer on and am ready to start the lacquer.
-
tippie53
- Posts: 7118
- Joined: Fri Mar 03, 2006 7:09 pm
- Location: Hegins, Pa
- Contact:
Re: Behlen Vinyl Sealer Problem
often if you spray in higher humidity you may see some blushing on the lacquer as you build . This often will work its way out in a few days. WEAR A MASK
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
-
kencierp
Re: Behlen Vinyl Sealer Problem
Even in more moderate humidity areas it a good idea to have couple cans of "Blush Remover" Behlens does offer it for good reason, nitro blushing is very common because it drys so fast and traps the moisture. I believe BR is actually a very refined thinner which is slower drying. The product softens the surface and allows the moisture to escape.