Neck taper details

What're You Doing?
Post Reply
tippie53
Posts: 7012
Joined: Fri Mar 03, 2006 7:09 pm
Location: Hegins, Pa
Contact:
Contact tippie53

Re: Neck taper details

Post by tippie53 »

only thing I would say is to work off center lines then cop and paste to pair up
that way you can be sure the taper is centered
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Top
MaineGeezer
Posts: 1714
Joined: Wed Aug 13, 2014 12:14 pm

Re: Neck taper details

Post by MaineGeezer »

Diane Kauffmds wrote: ↑Thu Feb 23, 2023 8:36 am I've read that:

the width of the neck at 12th fret = string spacing on bridge.

I think it's meant as a guide but not chiseled in stone.
Going by the sketch I did, that's off by 1/8".
Don't believe everything you know.
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
Top
Diane Kauffmds
Posts: 3252
Joined: Sun Mar 09, 2014 8:13 pm

Re: Neck taper details

Post by Diane Kauffmds »

It's good to have this info. I would so the Calc, personally.
Diane Kauffmann
Country Roads Guitars
countryroadsguitars@gmail.com
Top
Post Reply

Return to “Guitar Building Procedures”