Page 1 of 1
Grover Sta-Tites
Posted: Wed Aug 10, 2011 4:45 pm
by Tony_in_NYC
Anyone ever use 'em? They look sweet and I have a set on the way. Just wondering if there are any tips on installing them. Thanks in advance for the help!
Tony
Re: Grover Sta-Tites
Posted: Wed Aug 10, 2011 4:48 pm
by deadedith
I put a set on the 000 I built for the Parson Redheads. Installed easily, looked FINE, have been standing up to the rigors of the road real well.
Re: Grover Sta-Tites
Posted: Wed Aug 10, 2011 7:46 pm
by Ben-Had
I love em. One of my favorites sets. Getting ready to put them on my next (a sinker redwood top, EIR B/S, zebrawood binding, end wedge, and rosette).
Re: Grover Sta-Tites
Posted: Wed Aug 10, 2011 8:00 pm
by Tony_in_NYC
I was having buyer's remorse after I placed my order. Thanks for alleviating my fears!
Re: Grover Sta-Tites
Posted: Wed Aug 10, 2011 8:05 pm
by Oval Soundhole
I have a set of Waverly's on one of my Martins and these Grovers on the others. I prefer the Grovers.
Re: Grover Sta-Tites
Posted: Wed Aug 10, 2011 8:59 pm
by Tony_in_NYC
Oval Soundhole wrote:I have a set of Waverly's on one of my Martins and these Grovers on the others. I prefer the Grovers.
Good to know! Thanks for that info!
Re: Grover Sta-Tites
Posted: Thu Aug 11, 2011 5:32 pm
by Tom West
Tony: It's good to make sure the hole underneath your bushing counterbore in the headplate is .250.I think the shafts are .249 and this gives extra support to the shaft. Hope I didn't make this confusing.
Tom
Re: Grover Sta-Tites
Posted: Thu Aug 11, 2011 8:57 pm
by Tony_in_NYC
I got it Tom. Thanks for the info.