Page 1 of 1
Fret tang gaps
Posted: Wed Jun 04, 2014 5:30 pm
by mdutko
I fretted up my board today, the tangs don't extend down to the bottom of the slots so there is a little gap visible from the side. Suggestions on filling these? I was thinking sanding dust from the board mixed with CA or yellow glue? Thanks
Re: Fret tang gaps
Posted: Wed Jun 04, 2014 6:49 pm
by tippie53
dust and CA
Re: Fret tang gaps
Posted: Thu Jun 05, 2014 8:03 am
by B. Howard
That or a burn in stick.
Re: Fret tang gaps
Posted: Sat Jun 07, 2014 6:48 am
by ruby@magpage.com
A tip I found on the internet was to sand along the length of the side of the board and the gaps will be filled with dust, then a drop of CA.
Re: Fret tang gaps
Posted: Sat Jun 07, 2014 3:36 pm
by mdutko
Thats exactly what I did...worked perfectly