Ebony Bindings
-
scamp
- Posts: 322
- Joined: Sat Mar 26, 2022 8:19 pm
Ebony Bindings
Need to bend rather thick ebony bindings for the guitar I’m building ( 0.08 inch thick ). Using a Fox type bender I got from John Hall. Any recommendations on temperature etc to optimize success?
-
jread
- Posts: 615
- Joined: Wed Feb 13, 2019 9:52 am
- Contact:
Re: Ebony Bindings
I’ve bent ebony bindings on that bender a few times and haven’t had them break while bending. But they are brittle and I’ve broken a few while mishandled them during install. They will snap if you drop it or catch them on something. I bend the lower bout @240F and the upper around 250-260f including cutaway too. Then bring up to 325, then reduce to 250f for 15 min. My last set was .08”. They look great when done.
You do not have the required permissions to view the files attached to this post.
-
scamp
- Posts: 322
- Joined: Sat Mar 26, 2022 8:19 pm
Re: Ebony Bindings
Very helpful. Thanks.jread wrote: ↑Mon Mar 17, 2025 9:10 pm I’ve bent ebony bindings on that bender a few times and haven’t had them break while bending. But they are brittle and I’ve broken a few while mishandled them during install. They will snap if you drop it or catch them on something. I bend the lower bout @240F and the upper around 250-260f including cutaway too. Then bring up to 325, then reduce to 250f for 15 min. My last set was .08”. They look great when done.