DIY Duplicating Rig
Posted: Fri Nov 04, 2022 6:29 am
Have been working on a neck/bridge duplicating machine for the past few weeks. First attempt was a POS and I lost interest but saw a better plan on Y Tube and resumed the project.
The 2nd effort uses a lot more roller bearings and runs a lot smoother almost with no resistance. Still somewhat of a kludge but less kludger(sp) that the 1st attempt.
I have to make a real clean and straight master neck to dup the next few days and then will do the 1st trial. Will also do a bridge. I have a 1/8" and 1/4" ball mill cutters, will try the 1/4" first and see how it goes. A few pics....
Bruce,
The 2nd effort uses a lot more roller bearings and runs a lot smoother almost with no resistance. Still somewhat of a kludge but less kludger(sp) that the 1st attempt.
I have to make a real clean and straight master neck to dup the next few days and then will do the 1st trial. Will also do a bridge. I have a 1/8" and 1/4" ball mill cutters, will try the 1/4" first and see how it goes. A few pics....
Bruce,