Page 1 of 1
Lining kerfing jig
Posted: Fri Feb 26, 2016 8:43 pm
by ruby@magpage.com
We have all seen these, but I wanted something simple and the results it gives are great:
https://www.flickr.com/photos/ruby1638/ ... 606115293/
Ed
Re: Lining kerfing jig
Posted: Thu Mar 03, 2016 4:47 pm
by Kevin Sjostrand
Ed, it looks like you got nice even spacing, and very consistent depth of cut. Did you just eye ball these? They look better than the ones I've made.
Re: Lining kerfing jig
Posted: Thu Mar 03, 2016 6:33 pm
by ruby@magpage.com
Kevin
The jig determines the depth, so that is a given. The two marks at 5/16" from the center of the blade, then 5/8" (2 X 5/16") make it very easy to get even spacing because you are looking at 2 of them and averaging, not just one. I might make a third mark at an additional 5/16" to see if that makes it even easier.
Ed
Re: Lining kerfing jig
Posted: Thu Mar 03, 2016 7:28 pm
by Kevin Sjostrand
Ah, I see now the stop block is in the miter channel. Good idea.