Ken Hudley is right on the mark -- every Martin rim goes through two sanding stations to clean up and establish the neck set slope on the top edge of the rim and neck block (effectively making the block shorter) and also a sander to create a matching back perimeter dome. Check it out here's Chris Thomas from Martin explaining the process:
http://www.youtube.com/watch?v=rAu3Nw4KYdo
Martin Bolt-OnNeck Problem
General Information about Building Kit Guitars
Jump to
- Bending Library From Blues Creek Guitars
- General Information
- ↳ Building Tools
- ↳ Guitar Building Procedures
- ↳ Finishing Your Guitar
- ↳ Reference Library of Guitar Tops
- ↳ Restorations and Renovations
- ↳ Guitar Setup
- ↳ Guitar String Reviews and Discussion
- ↳ Repairs
- ↳ Special Guitar Tips
- ↳ Show It Off!
- ↳ Blog Your Project
- ↳ Events
- ↳ New Members Introductions
- ↳ Local Luthier Networking
- ↳ Photo of the Day
- Building From Scratch
- ↳ Guitars
- ↳ Ukuleles
- ↳ Mandolins
- ↳ Other Instruments
- Building From Kits
- ↳ Beginners' Questions
- ↳ Kit Guitars
- ↳ Kit Ukuleles
- ↳ Kit Mandolins
- ↳ Kit Electric Guitars
- Reference
- ↳ Reference Materials
- Tutorials
- ↳ John Hall's Quick Tip Videos
- ↳ DVD's and VHS
- ↳ Books & Magazines
- ↳ Online Tutorials
- Trading Post
- ↳ Guitars and Guitar Parts
- ↳ Lutherie Books and Magazines
- ↳ Lutherie DVDs and Tapes
- ↳ Lutherie Tools, Jigs, Molds
- ↳ Wanted to Buy or Trade
- ↳ Bargains
- Everything Else
- ↳ Anything Else
- ↳ Forum Software Questions and Answers