You must be logged-in to access this page.

Most Recent Comments:

Redo on a crooked center back brace
Inlay Epoxy
Dennis W guitar #1 - Martin 000-18 ket
Bridge Glue failure
Finally some progress on #2
SE Asian Flyfishin' Guitar
Stew Mac Kit - Back and Sides don't match.
#1 - Rosewood/Sitka OM
Bracing Back and Sound board..Technique Question.
Dimensions of a Standard Martin Headstock
French Polishing With "Hard Shellac"
Birchwood Casey Sealer & Filler
#2 finished
Anyone familiar with a Mandocello??
Guitar Label
First OM done
Strap End Pin Location
Stewart-MacDonald Dreadnought
Mask tuner holes when you finish the headstock?
Gluing on the back
HELP...Bit slipped loose while routing binding channel
finish with no pore filler?
Koa and breaclaw spruce dred- A LEFTY
Maton factory tour (lots of pictures!)
How does Stewmac side radius work???
Freaking out over bridge placement!
Neck adjustment: tilting the neck up: shim or shave?
How'd you begin . . .
Inlay dots: brad point bit essential?
where you all from
Mistakes from a beginner's perspective
great finish discussion
Cauls for the head and tail blocks
I'm such an idiot... how do I fix this now?
Rosette woods
Major Surgery Next Week: Andy and Melissa
Rim disaster: advice on bending a small bit of mahogany?
Glue questions
How Big A Mistake Can YOU Make? Bet I've Got You Beat!
Should I panic?
World Economic Crisis Costs Aussies Out Kit Guitar Building
The Wacky Ways Of Weldon
Where is everyone?????
I'll post a pic of a prototype upgrade bridge squarer, soon
Rosette channels too tight
Underhang on the top (ratehr than overhang...)
BRACE ENDS AT .100
Profile on LMII Dread neck? Trying to decide on first kit.
Nut slot widths
Stew Mac rosette channel too thin
Radius and sanding board discussion


BACK