Page 1 of 1
shaping center seam brace
Posted: Sat Mar 30, 2013 3:38 pm
by bnjp
Re: shaping center seam brace
Posted: Sat Apr 06, 2013 10:37 am
by Dave Sayers
Just about to start a 000 stew mac kit and I have the neck radius 16 degree blocks I bought from a man in Portugal. I shall take your advice. Many thanks. For the EU people among us here is a start to guitarwoodsupplies.
Everything I have bought has been good.
http://www.ebay.co.uk/itm/Set-of-5-Sand ... 4ac329d13c
Re: shaping center seam brace
Posted: Wed Mar 26, 2014 5:37 pm
by Tom West
I glue the strip on back, rough plane and then have a caul similar to yours, but smaller, with sand paper to finish.
Tom
Re: shaping center seam brace
Posted: Wed Mar 26, 2014 6:38 pm
by Ben-Had
Tom West wrote:I glue the strip on back, rough plane and then have a caul similar to yours, but smaller, with sand paper to finish.
Tom
Me too.
Re: shaping center seam brace
Posted: Wed Mar 26, 2014 7:30 pm
by tippie53
me 2
Re: shaping center seam brace
Posted: Thu Jul 09, 2015 2:57 pm
by Bob Gleason
Good ideas. Thanks, Bob