Problem Pore Filling EIR
Posted: Fri Mar 10, 2017 9:46 pm
Hello,
This is my first post to this forum, so I hope I'm doing it correctly. I'm in the process of pore filling some EIR with Z-Poxy and I've noticed some darkening of the wood on the upper bout. I've used Z-Poxy on several other builds and I've never had this issue. The wood was very uniform prior to applying the epoxy and only showed up after applying it. I've sanded that area back to bare wood and it seems as the wood in that section is lighter and more porous when compared to before, but when I apply the Z-Poxy it darkens up again. Does anyone have any ideas what could have caused this and whether or not I can rectify the situation? Any suggestions would be appreciated. Thank you,
Tony
This is my first post to this forum, so I hope I'm doing it correctly. I'm in the process of pore filling some EIR with Z-Poxy and I've noticed some darkening of the wood on the upper bout. I've used Z-Poxy on several other builds and I've never had this issue. The wood was very uniform prior to applying the epoxy and only showed up after applying it. I've sanded that area back to bare wood and it seems as the wood in that section is lighter and more porous when compared to before, but when I apply the Z-Poxy it darkens up again. Does anyone have any ideas what could have caused this and whether or not I can rectify the situation? Any suggestions would be appreciated. Thank you,
Tony