www.KitGuitarsForum.com
http://www.kitguitarsforum.com/board/

how to copy a neck vid
http://www.kitguitarsforum.com/board/viewtopic.php?f=56&t=7349
Page 1 of 1

Author:  tippie53 [ Tue Jun 02, 2015 4:35 pm ]
Post subject:  how to copy a neck vid

here is a new video on you tube
https://www.youtube.com/watch?v=R8UmlGHUKy0

Author:  MaineGeezer [ Tue Jun 02, 2015 8:08 pm ]
Post subject:  Re: how to copy a neck vid

When I click on the link, I get a message that the video does not exist.

Author:  tippie53 [ Tue Jun 02, 2015 9:02 pm ]
Post subject:  Re: how to copy a neck vid

link is fixed
https://www.youtube.com/watch?v=R8UmlGHUKy0

Author:  Danl8 [ Wed Jun 03, 2015 7:33 am ]
Post subject:  Re: how to copy a neck vid

Nice video and idea for getting the shape copied! On the subject of necks, (maybe you've done this already) it would be of interest to have a video on how to carve the back of neck/head/volute area. I notice that Martin models this area with some variability. I've done two so far with good results, but it is really intimidating. Seeing others' approach would be good.
-d.

Author:  B Shuler2006 [ Wed Jun 03, 2015 12:59 pm ]
Post subject:  Re: how to copy a neck vid

Great video John! I have a Martin with a low oval I like and this help out! I'm wondering, how thin can I go on the profile without the neck snapping under tension?

Author:  tippie53 [ Wed Jun 03, 2015 3:36 pm ]
Post subject:  Re: how to copy a neck vid

It depends
I have not seen strings snap one but I have seen truss rods go through
I will post some neck specks later I have them somewhere

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/