www.KitGuitarsForum.com
http://www.kitguitarsforum.com/board/

Re-routing truss rod channel on Harmony Sovereign
http://www.kitguitarsforum.com/board/viewtopic.php?f=53&t=8532
Page 2 of 2

Author:  ruby@magpage.com [ Wed Sep 05, 2018 7:33 am ]
Post subject:  Re: Re-routing truss rod channel on Harmony Sovereign

Good points both - not having to glue the rod in and having the height correct so that the rod bears on the back of the fretboard with no slop.

A just installed a Blanchard rod and it is hard to believe that this one will ever break. A little more expensive at $40, but very smooth and sturdy

Ed

Author:  MaineGeezer [ Wed Sep 05, 2018 8:23 am ]
Post subject:  Re: Re-routing truss rod channel on Harmony Sovereign

Yes - I've been using the FlexStrong truss rods, of similar quality. After seeing one of those, or a Blanchard, most all the other truss rods out there look pretty crude by comparison.

Author:  Diane Kauffmds [ Sat Sep 08, 2018 7:21 am ]
Post subject:  Re: Re-routing truss rod channel on Harmony Sovereign

I just use a small chisel and a 3mm gouge. The gouge makes a U shaped channel so the rod lays down nicely with no rattle.

Page 2 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/