Hello all,
When installing a fretboard inlay set I made an incorrect assumption (yes, I know what assumptions can do to you) that all of the components of the set were the same thickness. I merrily routed along until I found that one piece was thicker than the others so I adjusted my depth to go deeper and successfully routed for that piece. But THEN, I forgot to reset my router depth for the next piece and, voila, I routed too deeply for the that piece by a few thousandths.
To correct for this I am thinking I can simply fill the bottom of the cavity with a bit of CA, activate it, and then come back with the router set to the correct depth and clean things up.
Does that sound like a good plan or does someone have a better idea?
Thanks,
Inlay routed too deep
-
- Posts: 75
- Joined: Sat Mar 24, 2018 5:41 pm
- Location: Durham, NC
Inlay routed too deep
------------
Rex
Rex
-
- Posts: 7013
- Joined: Fri Mar 03, 2006 7:09 pm
- Location: Hegins, Pa
- Contact:
Re: Inlay routed too deep
I use dust that matches the fretboard then gently work the pearl into the dust to get it level. That is not a biggie you should be fine. If you use CA don't use activator let it cure on its own
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
-
- Posts: 75
- Joined: Sat Mar 24, 2018 5:41 pm
- Location: Durham, NC
Re: Inlay routed too deep
This is a rosewood fretboard that I will ultimately dye to ebony. Should I use rosewood dust? Will that dye ok later?
Thanks John!
Thanks John!
------------
Rex
Rex
-
- Posts: 7013
- Joined: Fri Mar 03, 2006 7:09 pm
- Location: Hegins, Pa
- Contact:
Re: Inlay routed too deep
it should
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com