Martin Top radius

What're You Doing?
Post Reply
jbjewitt
Posts: 28
Joined: Wed Jul 02, 2014 12:56 pm
Location: Cleveland, Ohio
Contact:

Martin Top radius

Post by jbjewitt »

I read somewhere that Martin switched from a 40' to a 28' radius (which they use now) at some point. Do you know why they did this?

Am building a 00- 14 fret SS maple/sitka and was thinking of a 40' top Any issues with it?

Jeff
-Jeff Jewitt-
Jewitt Guitars
www.JewittGuitars.com

Homestead Finishing Products
www.homesteadfinishingproducts.com
MaineGeezer
Posts: 1711
Joined: Wed Aug 13, 2014 12:14 pm

Re: Martin Top radius

Post by MaineGeezer »

Just guessing, but I imagine it was to reduce the tendency for the top to crack with changes in humidity. A curved top will rise and fall. A flat top has no place to go.
A curved top will also, I think, better resist deformation from sting tension.

I am just guessing though. I may be way off.
Don't believe everything you know.
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
tippie53
Posts: 7011
Joined: Fri Mar 03, 2006 7:09 pm
Location: Hegins, Pa
Contact:

Re: Martin Top radius

Post by tippie53 »

I am an authorized Martin shop . Since we don't have the Martin assemble fixtures we find that a 28 foot
Martin uses about a 52 foot radius on the braces and they put a 1 1/2 degree angle into the sides for the neck angle .

https://www.youtube.com/watch?v=LrgRKKsxL-M&t=1130s

there is a slight dome in the side also . I find that this video works the best for me to attain the 1/2 in string height and the proper neck angle
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Post Reply