Sanding near the neck joint
-
- Posts: 15
- Joined: Wed May 23, 2012 6:05 pm
Sanding near the neck joint
Anyone have a tip or trick on sanding the upper bout where it meets the neck. I attach my necks before starting finishing and I'm having trouble sanding close to the neck heel. I always get a thin strip of pore filler and finish that I can't reach without sanding against the grain.
-
- Posts: 733
- Joined: Mon Jul 28, 2014 7:50 am
- Location: Chadds Ford, PA
Re: Sanding near the neck joint
When building classical guitars, I used to use scrapers to get at that area. Scrapers can be made in any size and shape to address the neck/body joint finishing. Goes without saying that what can be done before the neck/sides are joined should be.
-
- Posts: 1711
- Joined: Wed Aug 13, 2014 12:14 pm
Re: Sanding near the neck joint
Have you tried finishing before installing the necK?
Don't believe everything you know.
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
-
- Posts: 15
- Joined: Wed May 23, 2012 6:05 pm
Re: Sanding near the neck joint
I plan on finishing before attaching the neck on my next build, but I'm past that point on my two current guitars, so wanted to see if anyone had recommendations. I've had some luck wrapping sandpaper around a credit card.
-
- Posts: 2
- Joined: Thu Oct 27, 2016 2:48 pm
Re: Sanding near the neck joint
Try using adhesive backed sandpaper and trim it up to the edge of your sanding block.