MS D-18
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Finishing the neck finish.
You do not have the required permissions to view the files attached to this post.
Tim Benware
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Preparing the headstock for tuner hole drilling.
You do not have the required permissions to view the files attached to this post.
Tim Benware
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Then I drill the holes.
You do not have the required permissions to view the files attached to this post.
Tim Benware
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Gluing the neck on the body after double checking the final fit and finish.
You do not have the required permissions to view the files attached to this post.
Tim Benware
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Preparing the bridge location and bridge for gluing.
You do not have the required permissions to view the files attached to this post.
Tim Benware
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Here I'm putting the top radius into the bridge.
You do not have the required permissions to view the files attached to this post.
Tim Benware
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
Now I'll fine tune to the top. I add some 150 to the top, find my center line and fine sand the radius to the top.
You do not have the required permissions to view the files attached to this post.
Tim Benware
Re: MS D-18
Tim, in this photo, what is meant by 'switch to var?'
-tommy
-tommy
You do not have the required permissions to view the files attached to this post.
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: MS D-18
I have a control (variable speed router control) that controls the heat supply. By switching it from "Full" to "Variable" it controls the power allowing the heat blanket to slowly cool down to 220* at which time I turn the heat off. John sells them (I think) or Harbor Freight has them too.
http://www.bluescreekguitars.com/shop/i ... ucts_id=28
http://www.bluescreekguitars.com/shop/i ... ucts_id=28
Tim Benware
-
- Posts: 14
- Joined: Sat Dec 03, 2011 2:06 pm
- Location: United Kingdom
Re: MS D-18
Tim,
I am thoroughly enjoying your Blog. Many thanks.
Jim
I am thoroughly enjoying your Blog. Many thanks.
Jim
The Older I become, the better I used to be.