overcarved heel?
Posted: Tue Dec 01, 2020 9:53 am
calling for backup..
I am following the stewmac neck carving templates to get close then eyeball my necks. I overshot my target by a bit on this one. The shaft is good and on thickness spec. But the curve and the heel itself are a bit small. Does anyone have the eye or experience to know if I've built a neck that will snap in half or do you feel this will be OK? I don't need to carve it smaller, just need to bring it back to level w/ top. I have elevation and angle set. The heel got pretty small w/ all my overcorrections in angle. I leave it far rougher next time until after setting it.
thanks!
I am following the stewmac neck carving templates to get close then eyeball my necks. I overshot my target by a bit on this one. The shaft is good and on thickness spec. But the curve and the heel itself are a bit small. Does anyone have the eye or experience to know if I've built a neck that will snap in half or do you feel this will be OK? I don't need to carve it smaller, just need to bring it back to level w/ top. I have elevation and angle set. The heel got pretty small w/ all my overcorrections in angle. I leave it far rougher next time until after setting it.
thanks!