|Good tutorial for bending sides?
|Page 2 of 2|
|Author:||tippie53 [ Fri May 03, 2019 6:41 am ]|
|Post subject:||Re: Good tutorial for bending sides?|
they are 6 in wide outside to outside. Solid patterns are not needed the steel slats work with the outside. You can make them solid but you soon find out you have a lot of heavy patterns and storing them is a problem.
Also the open pattern allows for a faster heat up and cool down. they absorb heat. They also add to the cost
|Page 2 of 2||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group