Anyone tried this for binding?
-
- Posts: 827
- Joined: Thu Aug 12, 2010 9:11 pm
Re: Anyone tried this for binding?
Nice tail wedge!
-
- Posts: 41
- Joined: Mon May 11, 2009 8:47 am
Re: Anyone tried this for binding?
Thanks Tony, it is actually parallel and not a wedge. The camera lies yet again.
-
- Posts: 41
- Joined: Mon May 11, 2009 8:47 am
Re: Anyone tried this for binding?
It does look like a wedge. I have always done a wedge as they are very forgiving if you are a bit out with the cutting, this was a bit tricky for me a I had to get the width right and also the length but I managed to do it first time. I really like the way this one looks. I hope it sounds ok
-
- Posts: 477
- Joined: Thu Dec 03, 2009 9:25 am
- Location: Nacogdoches, Tx
Re: Anyone tried this for binding?
I used the KMG hand held router jig on my first 2, and will again on my 3rd. There's no way I know of that you can dig too deep with it. Worst case, a cut could be shallow. But it's worked very well for me.