www.KitGuitarsForum.com

Learn to Kit Build a Guitar. Learn to Scratch Build a Guitar. Learn EVERYTHING Guitars Here!
It is currently Wed Oct 23, 2019 5:57 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 15 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: KMG Binding Jig copy
PostPosted: Thu Sep 05, 2019 5:41 pm 
Offline

Joined: Mon Sep 21, 2015 9:43 pm
Posts: 75
It's a laminate trimmer but the way it's mounted I'm thinking router table rules apply.


Top
 Profile  
 
 Post subject: Re: KMG Binding Jig copy
PostPosted: Thu Sep 05, 2019 8:31 pm 
Offline

Joined: Thu May 24, 2012 8:03 am
Posts: 1119
Location: Chestertown Maryland
One more thing , with this machine your rout cutting so use a piece of tape on the sides , make the first cut , then make your final clean up cut with the tape off. That little bit makes for a nice clean rout and the tape supports the grain to help control tear out.


John

You say that the tape supports the grain for tear out - where is the tape? I am thinking along the side to hold the bit away a little, then with the tape off, the bit moves that much closer for the final cut - what grain is being supported??

Ed


Top
 Profile  
 
 Post subject: Re: KMG Binding Jig copy
PostPosted: Thu Sep 05, 2019 9:58 pm 
Offline

Joined: Mon Sep 21, 2015 9:43 pm
Posts: 75
Here's my foam cradle. By coincidence I also told my wife we need a new 'foamie' camping mattress.


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
 Post subject: Re: KMG Binding Jig copy
PostPosted: Thu Sep 05, 2019 10:23 pm 
Offline

Joined: Mon Jul 09, 2012 9:49 pm
Posts: 247
The foam cradle Ken supplied had a perimeter a couple of inches wide, the center was cut out. I think Ken kept mention of the pad vague and never offered pictures. I suspect he wasn't interested in enabling copies.

_________________
peter havriluk


Top
 Profile  
 
 Post subject: Re: KMG Binding Jig copy
PostPosted: Thu Sep 05, 2019 11:30 pm 
Offline

Joined: Mon Sep 21, 2015 9:43 pm
Posts: 75
Ahh! That makes total sense. That's why the guitar is hard to push down. If I change it I'll probably have to take some of the shims out from under the jig.

Thanks! That's a detail that is hard to find.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 15 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group