I guess this is more directed to John,
I just was wondering if you could send me a photo of the white plastic donut attached to your router base. I am installing this system on a colt and was wondering;
a) Do I attach the donut to the plastic base or just straight to the metal base without the plastic base attached?
b) Inset the screws on the donut side or pre-thread the white plastic donut and screw from the back side of the router base?
If you have any photos that would really be helpful.
Thanks
Blake.
binding tower question
-
- Posts: 29
- Joined: Fri Dec 16, 2011 1:53 pm
-
- Posts: 7011
- Joined: Fri Mar 03, 2006 7:09 pm
- Location: Hegins, Pa
- Contact:
Re: binding tower question
I don't have the colt but when I set them up I do counter sink the screw
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
-
- Posts: 29
- Joined: Fri Dec 16, 2011 1:53 pm
Re: binding tower question
Counter sink the donut from the front or surface that you are putting against the actual guitar?
Thanks
Blake
Thanks
Blake
-
- Posts: 7011
- Joined: Fri Mar 03, 2006 7:09 pm
- Location: Hegins, Pa
- Contact:
Re: binding tower question
from the guitar face side
John Hall
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com
Blues Creek Guitars Inc
Authorized CF Martin Repair Center
president of Association of Stringed Instrument Artisans
http://www.bluescreekguitars.com