www.KitGuitarsForum.com

Learn to Kit Build a Guitar. Learn to Scratch Build a Guitar. Learn EVERYTHING Guitars Here!
It is currently Thu Dec 14, 2017 10:34 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Mon Aug 09, 2010 11:06 pm 
Offline

Joined: Fri Jul 30, 2010 6:44 pm
Posts: 1665
Location: Arkansas
enalnitram wrote:
hi Darryl, How did your homemade jig turned out? It looked most impressive.


Not great, but not bad either. Where I had the most issue was from just south of the deepest point of the waist for about 5" - 6" toward the lower bout. That area is where the body depth changes quickly and I never was able to get the channel cut to the full depth there. Likely has something to do with the width of the base around the router bit. The rest went fairly well.

Still, as much as I hate buying the bearings for the SM or LMI bits......they provide a lot of control and it's one less variable to have to setup and worry about. The videos of John H. doing binding make it look fairly simple. I'm sure it's more difficult than John makes it look but seems about as simple as one can make the process.

_________________
Slacker......


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group