Fretboard binding tenor ukulele

Post Reply
ChuckBarnett
Posts: 136
Joined: Thu Jul 09, 2015 7:46 pm
Location: Arlington, WA

Fretboard binding tenor ukulele

Post by ChuckBarnett »

I am not at all sure how binding works with width of fretboard; it would seem to increase the overall width of the fingering surface by the two thicknesses of binding. And do you Install the binding before or after installing frets? My plan calls for specific dimensions at the nut and at the 14th fret for the width of the fretboard. Certainly that cannot change much, specifically it cannot get smaller? Anybody seen a good explanation of how binding works.

Bless y'all!
MaineGeezer
Posts: 1711
Joined: Wed Aug 13, 2014 12:14 pm

Re: Fretboard binding tenor ukulele

Post by MaineGeezer »

I trim the fretboard narrower by 2X the thickness of the binding so when the binding is applied the total width is correct.

Apply the binding before installing the frets. You'll have to remove a bit the tang at each end of the frets so the binding doesn't interfere with seating the frets in their slots.

StewMac sells a clipper made just for this, or you can use whatever ypu may have that works.
You do not have the required permissions to view the files attached to this post.
Don't believe everything you know.
Anything is possible if you don't know what you are talking about.
When things are bad, try not to make them any worse, because it is quite likely they are bad enough already. - French Foreign Legion
Post Reply