www.KitGuitarsForum.com
http://www.kitguitarsforum.com/board/

Top Plate brace location
http://www.kitguitarsforum.com/board/viewtopic.php?f=3&t=9019
Page 1 of 1

Author:  gatorbrit [ Sun Nov 03, 2019 1:43 pm ]
Post subject:  Top Plate brace location

Hello! I am building a stewmac 000 kit. Because I am stupid I glued the top brace almost an inch above where it should be. So instead of being about 3/8 inch above the #1 brace, it is about 1 1/4 inches above it (closer the the neck).

My choices are:
1. Try to unglue it and re-do it.
2. Add another brace between it and the #1 brace, essentially overbracing the top. (Safe but sure option)
3. Ignore it and not worry.

What are your thoughts? This is my first build, I am learning a lot, and I am ok with this guitar not being perfect. I just don't want it to fall apart!

Thanks
Rich

Author:  tippie53 [ Sun Nov 03, 2019 3:09 pm ]
Post subject:  Re: Top Plate brace location

if it can clear the neck block your ok if the neck block is in the way you will have to remove it

Author:  gatorbrit [ Sun Nov 03, 2019 6:13 pm ]
Post subject:  Re: Top Plate brace location

Yes I think it still clears the neck block. Thanks for the quick response!

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/