Well after 4 yrs, i have finally decided to finish my guitar kit from Martin. I have the box built, and binding installed. I have not cut out the mortise for the v neck yet though. It is still fully enclosed. Its been so long, i cant remember the exact pattern of the V that needs to be cut out. Whats the best way to do this? Should i start with a drill bit in the center to make a hole? I may not have done this in the right order, but its what I have now, so just looking for some advice.
Thanks!
T-roy
Cutting out around neck mortise in the body
-
- Posts: 5
- Joined: Sun Apr 03, 2011 3:08 pm
-
- Posts: 5
- Joined: Sun Apr 03, 2011 3:08 pm
Re: Cutting out around neck mortise in the body
Well this wasnt as hard as I was thinking. I just used a razor knife to trim this out
Re: Cutting out around neck mortise in the body
It usually isn't. Nice work.t-roy211 wrote:Well this wasnt as hard as I was thinking.
-tommy