Here is a short tutorial I have done on a subject I get asked about quite often. How to use a burn in stick to fill defects in preparation to finish your guitar. Enjoy.
Burn in fills
-
- Posts: 709
- Joined: Wed Jan 11, 2012 9:42 pm
- Location: Hummelstown, PA
- Contact:
Burn in fills
You never know what you are capable of until you actually try....
Brian Howard
www.brianhowardguitars.com
Taylor authorized service
Custom finishing services
Brian howard's guitar building & repair blog
http://www.brianhowardguitars.com
Brian Howard
www.brianhowardguitars.com
Taylor authorized service
Custom finishing services
Brian howard's guitar building & repair blog
http://www.brianhowardguitars.com
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: Burn in fills
Interesting process, thanks Brian. I have a knife oven, would that get hot enough to melt the sticks? I use it to heat my knifes when separating tops, binding etc. for repairs.
Tim Benware
-
- Posts: 2354
- Joined: Sat Apr 10, 2010 10:50 pm
- Location: Seattle
- Contact:
Re: Burn in fills
Brian, thanks for the demonstration tutorial. I have a Uke that I am preparing for finish today. I will use your burn in method to fill a couple of areas that I need filled. I have used burn stick for finish repairs. It never occurred to me to use them as part of prep.
-
- Posts: 709
- Joined: Wed Jan 11, 2012 9:42 pm
- Location: Hummelstown, PA
- Contact:
Re: Burn in fills
Tim, I think your oven would likely work fine but you will need to try it to find out. As I may have mentioned, different stick from different suppliers are made of different resins and have slightly different melting points.
You never know what you are capable of until you actually try....
Brian Howard
www.brianhowardguitars.com
Taylor authorized service
Custom finishing services
Brian howard's guitar building & repair blog
http://www.brianhowardguitars.com
Brian Howard
www.brianhowardguitars.com
Taylor authorized service
Custom finishing services
Brian howard's guitar building & repair blog
http://www.brianhowardguitars.com
-
- Posts: 1405
- Joined: Fri Sep 03, 2010 2:14 pm
- Location: Creedmoor, NC
Re: Burn in fills
Thanks.B. Howard wrote:Tim, I think your oven would likely work fine but you will need to try it to find out. As I may have mentioned, different stick from different suppliers are made of different resins and have slightly different melting points.
Tim Benware